Buy ButtKicker BKA1000-N Power AmplifierButtKicker BKA1000-N Power Amplifier Product Description:
- Power two ButtKicker LFEs when wired in parallel and four LFEs in individual seats
- Designed with RCA and 0.25-inch inputs with 160-volt and 1.25-volt sensitivities that eliminate the need for a separate pre-amplifier
- Includes a low cutoff filter for frequencies less than 25 Hz, and a variable high cutoff filter that can be set for frequencies above 40 to 160 Hz
- Provides 1900 watts at 2 ohms and 1000 watts at 4 ohms
- Measures 12 x 4.375 x 11 inches (WxHxD), and weighs approximately 25 lbs
Product Description
1900 watts @ 2 ohms, 1000 watts @ 4 ohms Can power up to 4 BK-LFE's Replaces BKA-1000-4. 120V version, for North American use only.
Customer Reviews
Most helpful customer reviews
5 of 5 people found the following review helpful.
Good for ButtKickers
By -TMcN-
What is it? A single-channel (mono) amp specificially for ButtKicker tactile transducers.What does it do? Powers ButtKicker magnetic pistons that you can bolt under your floor or inside your sofa/recliner to augment your bass and special effects. That works really well and is much cooler than it sounds.But that's the only thing you should use it for. ButtKickers, other tactile transducers (e.g. Clarks), and perhaps subwoofers. It doesn't do high frequencies. It doesn't do low distortion - which you will never notice at low frequencies. It won't even turn on until it detects very low frequencies. This is the engine of the ButtKicker. You want this, not your receiver, to power a ButtKicker (or Clark, etc) because you need raw power that can be a bit dirty for those. Your receiver pumps out expensive clean power, and not so much of it. So you need both.For the intended purpose, it's perfect. And, from experience, if it needs fixing, ButtKicker (Guitarhammer) just takes care of it. The absolute best customer service I've seen.
7 of 8 people found the following review helpful.
Awesome Class-D Amp!
By A. Help
This amp is a steal for either powering subwoofers (1000 W @ 4 Ohms, 2000 W @ 2 Ohms) with genuine clean power below 120 Hz. Being not fully shielded, it should indeed be kept away from other units...and plugged into its own outlet, preferably with its own GOOD UPS (uninterrupted power supply, the heavier the better).The Buttkicker SYSTEM (1-2 transducers per amp) is AMAZING. By itself it produces true radiation down to 5 Hz (one would need a 30+" woofer or a complex horn-loaded speaker). I have four of them, two drive Klipsch 15" subs for free-air radiation from 80 Hz (THX) down to 20 Hz and two of them drive a single buttkicker transducer, each from 5-80 Hz, so there's a TON of headroom for calibration at high levels.BUY THIS SYSTEM, nothing else compares!
2 of 2 people found the following review helpful.
Blows fuses, problems internally
By Steven H. Nielsen II
I have had my unit for 3 years and it worked great until now. It has been blowing fuses recently and now it just blew something inside. I opened it up and can see the damage. I would look at other options.
Latest Price: See on Amazon.com!
More Info: See on Amazon.com!
See Customers Review: See on Amazon.com!
